Download Print this page

GE RB524 Use And Care & Installation page 22

Advertisement

Surface Units and Drip Pans
To clean the surface units, turn the control to the highest
setting for a minute. The coils will burn off any soil.
CAUTION
Do not immerse the surface units in liquids of any kind.
Do not clean the surface units in a dishwasher.
Do not bend the surface unit plug terminals.
Do not attempt to clean, adjust or in any way repair
the plug-in receptacle.
To remove the drip pans for cleaning. the surface units
must be removed first. Make sure the surface units are
completely cool before touching them.
Lift the surface unit about 1 inch above the drip pan
and pull it out.
Do not lift the surface unit more than 1 inch.
If you do, it may not lie flat on the drip pan when
you plug it back in.
Repeated lifting of the surface unit more
than 1 inch above the drip pan can permanently
damage the receptacle.
Porcelain Enamel Cooktop
The porcelain enamel finish is
sturdy but breakable if misused.
This finish is
acid-resistant.
However, any acid foods spilled
(such as fruit juices, tomato or
vinegar) should not be permitted
to remain on the finish.
22
(continued)
To replace a surface unit:
Replace the drip pan into the recess in the
cooktop. Make sure opening in the pan lines up
with the receptacle.
the opening in the drip pan and into the receptacle.
Drip Pans
Remove the surface units. Then lift out the drip pans.
For best results, clean the drip pans by hand. Place
them in a covered container (or a plastic bag) with
The drip pans may also be cleaned in the dishwasher.
Drip Pan
Clean the area under the drip pans often.
Do not
to the receptacle could cause shock, fire or damage to
the range.
CAUTION: Be sure all controls are turned to
OFF and surface units are cool before attempting
to remove them.
If acids spill on the cooktop
while it is hot, use a dry paper
towel or cloth to wipe it up right
cooled, wash with soup and water.
cover drip pans with foil. Using foil so close
For other spills such as fat
smatterings, wash with soap and
water or cleansing powders after
the surface has cooled. Rinse well.
Polish with a dry cloth.

Advertisement

loading

This manual is also suitable for:

Rb532Rb533Rb536Rb525Rb632Rb526 ... Show all