Cleaning; Washing The Vehicle; Storage - Toro 07266 Operator's Manual

Table of Contents

Advertisement

Cleaning

Washing the Vehicle

The vehicle should be washed as needed. Use water
alone or with a mild detergent. A rag may be used,
however the hood will loose some of its luster.
Important: Pressurized water is not recommended
when washing the machine. It may damage the
electrical system, loosen important decals, or wash
away necessary grease at friction points. Avoid
excessive use of water, especially near the control
panel, engine, and battery.

Storage

1. Position the machine on a level surface, set the
parking brake, stop the engine, and remove the
ignition key.
2. Clean dirt and grime from the entire machine,
including the outside of the engine's cylinder head
fins and blower housing.
Important: You can wash the machine with
mild detergent and water. Do not use high
pressure water to wash the machine. Pressure
washing may damage the electrical system or
wash away necessary grease at friction points.
Avoid excessive use of water, especially near the
control panel, lights, engine, and the battery.
3. Inspect the brakes; refer to Inspecting the Brakes in
the Brake Maintenance section in Maintenance.
4. Service the air cleaner; refer to Servicing the Air
Cleaner in the Engine Maintenance section in
Maintenance.
5. Grease the machine; refer to Lubrication section in
Maintenance.
6. Change the engine oil; refer to Servicing Engine Oil
in the Engine Maintenance section in Maintenance.
7. Check the tire pressure; refer to Checking the Tire
Pressure.
8. For storage over 30 days, prepare the fuel system
as follows:
A. Add a petroleum based stabilizer/conditioner to
fuel in the tank.
Follow mixing instructions from stabilizer
manufacturer. (1 oz. per gallon). Do not use an
alcohol based stabilizer (ethanol or methanol).
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline and
used at all times.
B. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
C. Stop the engine, allow it to cool, and drain the
fuel tank.
D. Restart the engine and run it until it stops.
E. Choke the engine.
F. Start and run the engine until it will not start
again.
G. Dispose of fuel properly. Recycle as per local
codes.
38

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

07266tc0727307273tc07279Workman mdWorkman mdx

Table of Contents