Product Overview; Controls - Toro 07266 Operator's Manual

Product Overview

7
1. Hood strap
2. Parking brake

Controls

1. Brake pedal
2. Parking brake, center
console
3. Steering wheel
4. Cup holder
Accelerator Pedal
The accelerator pedal (Figure 5) gives the operator the
ability to vary ground speed of the vehicle. Pressing
the pedal starts the engine. Pressing the pedal farther
increases ground speed. Releasing the pedal will slow
1
3. Cargo box
4. Cargo box release lever
Figure 5
5. Passenger hand hold
6. Operator's Manual tube
7. Accelerator pedal
2
5
6
G014967
Figure 4
5. Fuel cap
6. Gear shift selector
the vehicle and the engine will stop running. Maximum
forward speed is 16 mph (26 km/h).
Brake Pedal
The brake pedal is used to stop or slow the vehicle
(Figure 5).
CAUTION
Brakes can become worn or can be incorrectly
adjusted resulting in personal injury.
If brake pedal travels to within 1 inch (25 mm) of
the vehicle floor board, the brakes must be adjusted
or repaired.
Parking Brake
The parking brake is between the seats (Figure 5).
Whenever the engine is shut off, the parking brake
must be engaged to prevent accidental movement of
the vehicle. To engage the parking brake, pull back on
the lever. To disengage, push the lever forward. If the
vehicle is parked on a steep grade, make sure that the
parking brake is applied.
Choke Control
The choke control is located below and to the right of
the operator's seat. To start a cold engine, pull the choke
13
3
4
7. Towing tongue