Maintenance; Recommended Maintenance Schedule(S) - Toro 07266 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 8 hours
After the first 25 hours
After the first 50 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 200 hours
Every 400 hours
Every 800 hours
Yearly
Important: Refer to your Engine Operator's Manual for additional maintenance procedures.
Maintenance Procedure
• Change the engine oil. (07273/TC)
• Check the condition of the drive belt.
• Check the tension of the starter generator belt.
• Change the engine oil (07266/TC).
• Inspect opening on filter.
• Check the engine oil.
• Check the tire pressure.
• Check the transmission oil level.
• Check gear shift operation.
• Check the brake fluid level.
• Change the engine oil (07273/TC). (twice as often in special operating conditions;
refer to Maintaining the Vehicle under Special Operating Conditions)
• Check the battery cable connections for wear or damage.
• Check the battery electrolyte level.
• Grease the bearings and bushings.
• Inspect and clean the air filter element (twice as often in special operating conditions;
refer to Maintaining the Vehicle under Special Operating Conditions).
• Change the engine oil (07266/TC). (twice as often in special operating conditions;
refer to Maintaining the Vehicle under Special Operating Conditions)
• Change the oil filter (07273/TC). (twice as often in special operating conditions; refer
to Maintaining the Vehicle under Special Operating Conditions)
• Check the spark plug (07266/TC).
• Check the operation of the Neutral gear shift position.
• Inspect the condition and wear of the tires.
• Torque the wheel lug nuts to 45-65 ft-lb (61-88 N-m).
• Check the front wheel toe-in and front suspension.
• Clean the engine cooling areas (twice as often in special operating conditions; refer
to Maintaining the Vehicle under Special Operating Conditions).
• Inspect the brakes.
• Replace the air filter element.
• Inspect opening on filter.
• Check the parking brake operation.
• Check the condition and tension of the drive belt.
• Check the tension of the starter generator belt.
• Inspect the fuel lines and connections.
• Clean the primary drive clutch.
• Replace the spark plugs (07273/TC).
• Replace the fuel filter.
• Change the transaxle fluid.
• Complete all yearly maintenance procedures specified in the Engine Operator's
Manual.
21