Setup; Installing The Steering Wheel; Activating The Battery - Toro 07266 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Note: Determine the left and right sides of the machine
from the normal operating position.
1

Installing the Steering Wheel

Parts needed for this procedure:
1 Steering wheel
Procedure
Note: This procedure is only needed for Model No.
07266TC and 07273TC.
1. Release the tabs on the back of the steering wheel
that hold the center cover in place. Remove the cover
2. Remove the nut and washer from the steering shaft.
3. Slide the steering wheel and washer onto the shaft.
Position the steering wheel on the shaft so that the
cross beam is horizontal when the tires are pointed
straight ahead and the thicker spoke of the steering
wheel is downward.
4. Secure the steering wheel to the shaft with the nut
(Figure 3). Torque the nut to 18-22 ft-lb (24-29 N-m)
Description
Steering wheel
No parts required
Operator's Manual
Engine Operator's Manual
Parts Catalog
Safety Training material
Registration Card
Predelivery Inspection Form
Certificate of Quality
Key
Qty.
Install the steering wheel (Model
1
07266TC and 07273TC only).
Activate the battery (Model 07266TC
–
and 07273TC only).
1
1
1
Read the Operator's Manual and view
1
the training material before operating
1
the machine.
1
1
2
1. Steering shaft
2. Foam seal
3. Steering wheel
4. Tab slots in wheel
5. Snap the center cover in place.
2

Activating the Battery

No Parts Required
Procedure
None
11
Use
Figure 3
5. Washer
6. Nut
7. Cover
8. Tabs in cover