Key Switch; Pto Switch; Light Switch; Seat Adjustments - Toro 30881 Operator's Manual

Key Switch

The key switch (Figure 10) has 3 positions: Off, On/Preheat,
and Start.

PTO Switch

The PTO switch (Figure 10) has 2 positions: Out (start) and
In (stop). Pull the PTO button out to engage the cutting
unit blades. Push in the button to disengage the cutting unit
blades.
High-Low Speed Control
The switch (Figure 10) allows the speed range to increase
for transporting the machine. To switch between the High
and Low speed ranges, raise the decks, disengage the PTO,
put the traction pedal into the N
the machine at a slow speed.
Note: The cutting decks do not operate and/or cannot be
lowered from the transport position when the switch is in
the high range.
Figure 10
1. Lift switches
(Groundsmaster 4700
only)
2. Lift switch (Groundsmaster
4500 and 4700)
3. PTO switch
4. Key switch
5. InfoCenter
Engine-Speed Switch
The engine-speed switch (Figure
the engine speed. Tap the switch to increase or decrease the
engine speed in 100 rpm increments. Hold down the switch
to automatically move to High or Low idle, depending on
which end of the switch is depressed.
Lift Switches
The lift switches (Figure 10) raise and lower the cutting
units. Press the switches forward to lower the cutting units
position, and move
EUTRAL
6. Hi-Lo speed control
7. Engine-speed switch

8. Light switch

9. Cruise control
10) has 2 modes to change
and backward to raise the cutting units. When starting the
machine, with the cutting units in the down position, press the
lift switch down to allow the cutting units to float, and mow.
Note: The decks do not lower while in the Hi speed range
and they do not raise or lower if the operator is out of the seat
when the engine is running. To lower the decks for service,
rotate the key in the ignition switch to the O
sitting in the seat.
Light Switch
Press the lower edge of the switch
lights. Press the upper edge of the switch to turn off the lights.
Power Point
Use the power point (Figure
electrical accessories.
1. Power point
Bag Holder
Use the bag holder (Figure

Seat Adjustments

Seat Adjusting Lever
Pull out on the lever to slide the seat forward or rearward
(Figure 12).
Seat Arm Rest Adjusting Knob
Rotate the knob to adjust the seat arm rest angle.
Seat Back Adjusting Lever
Move the lever to adjust the seat back angle
14
position while
N
(Figure 10) to turn on the
11) to power optional 12 V
g020512
Figure 11
2. Bag holder
11) for storage.
(Figure 12).