Toro 30881 Operator's Manual page 34

•
Steering cylinder ball joints (2)
1. Top fitting on king pin
•
Tie-rod ball joints (2)
•
King-pin bushings (2)
the king pin should only be lubricated annually
(2 pumps).
•
Lift-arm bushings (1 per deck)
•
Lift-cylinder bushings (2 per deck)
(Figure 23)
Figure 23
(Figure 23)
(Figure 23). The top fitting on
(Figure 24)
Figure 24
(Figure 24)
•
Cutting unit spindle-shaft bearings (2 per cutting unit)
(Figure 25)
Note: You can use either fitting, whichever is more
accessible. Pump grease into the fitting until a small
amount appears at bottom of the spindle housing (under
the deck).
•
Cutting unit carrier-arm bushings (1 per cutting unit)
(Figure 25)
•
Rear roller bearings (2 per cutting unit)
Important: Make sure that the grease groove in
each roller mount aligns with the grease hole in each
end of the roller shaft. To help align the groove and
hole, there is also an alignment mark on 1 end of the
roller shaft.
34
Figure 25
(Figure
Figure 26
26)