Yamaha RX-V692 Owner's Manual page 15

How to Connect:
Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are
faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is the + and –
markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.
Caution
Do not let the bare speaker wires touch each other and do not let them touch any metal part of this unit. This could damage
this unit and/or speakers.
For connecting to the MAIN SPEAKERS terminals
Red: positive (+)
Black: negative (–)
2
1
3
Banana Plug connections are also possible (except for
Singapore model). Simply insert the Banana Plug connector
into the corresponding terminal.
For Custom Installer
REMOTE CONTROL (IN, OUT) terminals
These terminals are used for custom installation system.
When this unit is connected to the components for custom
installation system, you can operate this unit with the
system remote control.
Connect the REMOTE CONTROL IN terminal of this unit to
the output terminal of the central controller for custom
installation system.
By connecting the REMOTE CONTROL OUT terminal of
this unit to the REMOTE CONTROL IN terminal of the other
component, you can also operate it with the system remote
control. In this way, up to 6 components can be connected
in series.
Unscrew the knob.
Insert the bare wire.
[Remove approx. 5mm
(1/4") insulation from
the speaker wires.]
Tighten the knob and
secure the wire.
For U.S.A. and Canada models of RX-V692 only
For connecting to the REAR and CENTER SPEAKERS
terminals
Red: positive (+)
Black: negative (–)
UT DVD/LD TV/DBS
REMOTE CONTROL
ER SURROUND
IN
ON SCREEN SELECTOR
B
S VIDEO VIDEO
ER
VIDEO SIGNAL
Press the tab.
Insert the bare wire.
[Remove approx. 5mm
(1/4") insulation from
the speaker wires.]
Release the tab and
secure the wire.
OUT
13