Onkyo TX-SR876 User Manual page 99

Advanced Setup—Continued
18
Press the [SETUP] button.
Setup closes.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
Speaker Distance
These settings are set automatically by the Automatic
Speaker Setup function (see page 64).
With the "Speaker Distance" settings, you can specify
the distance from each speaker to the listening position.
You can set the distances for front Speakers A and front
Speakers B independently. The other speakers (i.e., sub-
woofer, center, surround, and surround back) use the
same distance settings for Speakers A and Speakers B.
REMOTE MODE
DVD VCR
CDR/MD/DOCK
TV CABLE
SAT
DIMMER
4-8
+
CH
ENTER
DISC
ALBUM
-
3, 9
PREV
CH
DISPLAY
REC
PLAYLIST
SP A
LISTENING MODE
STEREO SURR
REPEAT AUDIO SUBTITLE
PURE A DIRECT
1 Measure and make a note of the
distance from each speaker to
the listening position.
2 Press the [RECEIVER] REMOTE
MODE button, and then use the
remote controller's [SP A] or
[SP B] button to select Speakers
A or Speakers B, respectively
(TX-NR906 only).
Note:
• Speakers B cannot be selected if
"Speaker Type: Front(Speaker B)" is
set to "Not Use".
• TX-SR876 continue with step 3 after
press the [RECEIVER] REMOTE
MODE button.
CD ZONE 2
2
NET/USB RECEIVER
TAPE/AMP
SLEEP
VOL
MUTING
RANDOM
2*
SP B
PLAY MODE
THX ALL ST
*TX-NR906 only
3
Press the [SETUP] button.
The main menu appears onscreen.
4
Use the Up and Down [q]/[w] but-
tons to select "2. Speaker
Setup", and then press [ENTER].
The "Speaker Setup" menu appears.
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
MOVE
5
Use the Up and Down [q]/[w] but-
tons to select "3. Speaker Dis-
tance", and then press [ENTER].
The "Speaker Distance" screen
appears.
2–3. Speaker Distance
Unit
Left
Center
Right
SurrRight
SurrBack R
SurrBack L
SurrLeft
Subwoofer
MOVE
Note:
Speakers that you set to "No" or
"None" in the Speaker Configuration
(page 95) cannot be selected.
6 Use the Up and Down [q]/[w] but-
tons to select "Unit", and then
use the Left and Right [e]/[r]
buttons to select:
feet: Select if you want to enter
distances in feet. Can be set
from 0.5 to 30 feet in 0.5-foot
steps.
meters: Select if you want to enter
distances in meters. Can be
set from 0.15 to 9 meters in
0.15-meter steps.
ENTER RETURN EXIT
ENTER RETURN SETUP
feet
12.0ft
Speaker A
12.0ft
12.0ft
12.0ft
12.0ft
12.0ft
12.0ft
12.0ft
VALUE RETURN RETURN SETUP EXIT
99