Onkyo TX-SR876 User Manual page 96

Advanced Setup—Continued
5 Use the Up and Down [q]/[w] but-
tons to select "Subwoofer", and
then use the Left and Right
[e]/[r] buttons to select:
Note:
The same setting is used for Speakers A
and Speakers B.
6
Use the Up and Down [q]/[w] but-
tons to select "Front", and then
use the Left and Right [e]/[r]
buttons to select a crossover fre-
quency.
Notes:
• This setting can be set independently
for front Speakers A and front
Speakers B.
• Fixed at "Full Band" if "Subwoofer"
(step 5) is set to "No".
7
Use the Up and Down [q]/[w] but-
tons to select "Center", and then
use the Left and Right [e]/[r]
buttons to select a crossover fre-
quency.
If no center speaker is connected, select
None.
Notes:
• The same setting is used for Speakers
A and Speakers B.
• Can be set if the currently selected
speakers (Speakers A or Speakers B)
is set to "BTL" (page 61).
• Cannot select "Full Band" if "Front"
(step 6) is set to anything other than
"Full Band".
• For Speakers B, if any channel is set
to "Full Band", "Center" is fixed at
"Full Band".
96
Yes: Select if a subwoofer is con-
nected.
No: Select if no subwoofer is con-
nected.
8 Use the Up and Down [q]/[w] but-
tons to select "Surround", and
then use the Left and Right
[e]/[r] buttons to select a cross-
over frequency.
If no surround left and right speakers
are connected, select "None".
Notes:
• The same setting is used for Speakers
A and Speakers B.
• Can be set if the currently selected
speakers (Speakers A or Speakers B)
is set to "BTL" (page 61).
• Cannot select "Full Band" if "Front"
(step 6) is set to anything other than
"Full Band".
9 Use the Up and Down [q]/[w] but-
tons to select "SurrBack", and
then use the Left and Right
[e]/[r] buttons to select a cross-
over frequency.
If no surround back speakers are con-
nected, select "None".
Notes:
• The same setting is used for Speakers
A and Speakers B.
• Cannot be set if "Speaker Type:
Front(Speaker A) or Front(Speaker
B)" is set to "Bi-Amp" or "BTL"
(page 61), "Surround" is set to
"None" (step 8), or "Powered
Zone2" is being used (page 132).
• Cannot select "Full Band" if "Sur-
round" (step 8) is set to anything
other than "Full Band".
10 Use the Up and Down [q]/[w] but-
tons to select "SurrBack Ch",
and then use the Left and Right
[e]/[r] buttons to select:
1ch: Select if one surround back
speaker is connected.
2ch: Select if two (left and right)
surround back speakers are
connected.
Notes:
• The same setting is used for Speakers
A and Speakers B.
• Cannot be set if "Speaker Type:
Front(Speaker A) or Front(Speaker
B)" is set to "Bi-Amp" or "BTL"
(page 61), "SurrBack" is set to
"None" (step 9), or "Powered
Zone2" is being used (page 132).
Continue with step 11 on the next page.