Speaker Settings - Onkyo TX-SR876 User Manual

First Time Setup—Continued

Speaker Settings

4 5
TAPE TUNER
If you change these settings, you must run the auto-
7 8
matic speaker setup again (see page 64). PHONO NET/USB
+10
0
--/--- 10
INPUT SELECTOR
MACRO
1 2
REMOTE MODE
DVD VCR
TV CABLE
SAT
DIMMER
2, 3
+
CH
ENTER
DISC
ALBUM
-
1, 7
PREV
CH
DISPLAY
REC PLAYLIST
If the impedance of any speaker is 4 ohms or more but
less than 6, set the Speaker Impedance to 4 ohms.
To use bi-amping or bridging, you must change the
"Speaker Type" setting. For hookup information, see
pages 27–30.
Notes:
• When bridging is used, the AV receiver is able to drive
up to 5.1 speakers in the main room.
• When bi-amping is used, the AV receiver is able to
drive up to 5.1 speakers in the main room.
• Before you change these settings, turn down the vol-
ume.
The onscreen menus shown in this manual may be
slightly different from what you see on your TV.
1 Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn't appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [q]/[w] but-
tons to select "2. Speaker
Setup", and then press [ENTER].
The "Speaker Setup" menu appears.
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
-
6
CD
9
TV VOL
D. TUN
CLEAR
11 12
3 ZONE 3
CD ZONE 2
CDR/MD/DOCK
1
NET/USB RECEIVER
TAPE/AMP
SLEEP
2–6
VOL
MUTING
RANDOM
3
Use the Up and Down [q]/[w] but-
tons to select "1. Speaker Set-
tings", and then press [ENTER].
The "Speaker Settings" menu appears.
2–1. Speaker Settings
Speaker impedance
Speaker Type
Front(Speaker A)
Front(Speaker B)
MOVE
4
Use the Up and Down [q]/[w] but-
tons to select "Speaker imped-
ance", and use the Left and Right
[e]/[r] buttons to select:
4ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
5
Use the Up and Down [q]/[w] but-
tons to select "Front(Speaker
A)", and use the Left and Right
[e]/[r] buttons to select:
Normal:
Select this if you've connected your
front Speakers A normally.
Bi-Amp:
Select this if you've connected your
front Speakers A for bi-amped
operation.
BTL:
Select this if you've connected your
front Speakers A for bridged opera-
tion. The BTL indicator will appear
on the display.
Note:
"Bi-Amp" and "BTL" cannot be
selected if "Front(Speaker B)" is set to
"Bi-Amp" or "BTL".
6ohms
Normal
Not Use
VALUE RETURN RETURN SETUP EXIT
61