Error Messages - Onkyo TX-SR876 User Manual

First Time Setup—Continued

Error Messages

While the automatic speaker setup is in progress, one of
the following error messages may appear:
❑ Ambient noise is too high
Auto Speaker Setup
Retry
Cancel
!
MOVE
This message appears if the background noise is too
loud and the measurements cannot be performed
properly.
Remove the source of the noise and try again.
Retry: Return to the measured point immediately
before and start set up again.
Cancel: Cancel the automatic speaker setup.
❑ Speaker Detect Error
Auto Speaker Setup
Next
Cancel
:Yes
:---
!
MOVE
This message appears if a speaker is not detected. "Yes"
means that a speaker was detected. "No" means that no
speaker was detected. Check your speaker connections
and retry, or cancel the automatic speaker setup.
Auto Speaker Setup
Next
Cancel
:Yes
:---
!
MOVE
The front right speaker has not been detected.
Auto Speaker Setup
Next
Cancel
:Yes
:---
!
MOVE
The surround right speaker has not been detected.
68
Ambient noise is too high.
ENTER
ENTER
:No
!
:Error
Speaker Detect Error
ENTER ENTER
:No
!
:Error
Speaker Detect Error
ENTER
ENTER
:No
!
:Error
Speaker Detect Error
ENTER ENTER
Auto Speaker Setup
Next
Cancel
:Yes :No
!
:--- :Error
! Speaker Detect Error
MOVE
ENTER
The surround back left speaker has not been detected.
Auto Speaker Setup
Next
Cancel
:Yes :No
!
:--- :Error
! Speaker Detect Error
MOVE ENTER
There is a problem with the front left speaker. If the
warning triangle ( ) appears for the subwoofer, it may
be that the output from the subwoofer is too loud.
Auto Speaker Setup
Retry
Cancel
! Speaker Detect Error
MOVE
ENTER
The number of speakers detected on the second or
third measurement was different to the number
detected on the first measurement.
Make sure speakers that cannot be detected are con-
nected property.
Retry: Return to step 2 and try again.
Cancel: Cancel the automatic speaker setup.
❑ Writing Error!
Auto Speaker Setup
Retry
Cancel
Writing Error!
!
MOVE ENTER
This message appears if saving fails.
Try saving again. If this message appears after 2 or 3
attempts, the AV receiver is probably malfunctioning.
Contact your Onkyo dealer.
Retry: Return to step 2 and try again.
Cancel: Cancel the automatic speaker setup.
ENTER
!
ENTER
ENTER
ENTER