Changing The Engine Oil Filter - Toro 74824 Operator's Manual

Note: Dispose of the used oil at a recycling center.
1. Start the engine and let it run five minutes. This
warms the oil so it drains better.
2. Park the machine so that the drain side is slightly
lower than the opposite side to assure the oil drains
completely.
3. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
4. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position (Figure 38).
1
3
5
2
4
6
Figure 38
5. Slowly pour approximately 80% of the specified oil
into the filler tube and slowly add the additional oil
to bring it to the Full mark (Figure 39).
G009950

Changing the Engine Oil Filter

Service Interval: Every 200 hours—Change the oil
Note: Change the engine oil filter more frequently
when operating conditions are extremely dusty or sandy.
1. Drain the oil from the engine; refer to Changing the
Engine Oil.
2. Change the engine oil filter (Figure 40).
G011157
33
1
2
4
3
6
5
Figure 39
filter. (more often in dusty, dirty
conditions)
G008796