Table of Contents
Advertisement
2. Remove retaining rod from seat and insert the L
shaped end of the rod into the hole directly above the
left–side hydraulic pump (Fig. 3).
3. Place the seat retaining rod to the outside of the
mounting tab of the seat frame and secure with a bolt
(5/16 x 1 in.) bolt and a lock nut (5/16 in.) locknut
(Fig. 3).
4. Tighten until snug, then loosen so the rod pivots freely.
2
Figure 3
1. L end of retaining rod
2. Locknut, 5/16 in.
Installing Motion Control
Levers
1. Remove the 4 bolts (3/8 x 1 in.) bolts and 4 spring
washers (3/8 in.) which attach the motion control
levers to the control arm shafts for shipping (Fig. 4).
2. Place the levers (with the mounting plate towards the
rear) on the outside of the control arm shaft and secure
with 4 bolts (3/8 x 1 in.) bolts and 4 spring washers
(3/8 in.) (Fig. 4).
3. Position the lever so the bolts are in the center of the
slots on the lever mounting plate and tighten until
snug.
4. Align the front\rear position of the levers, with each
other, in the neutral position. Loosen hardware and
adjust by sliding/tilting the lever(s) forward or
backward until properly aligned (Fig. 4).
1
3
m–3750
3. Bolt, 5/16 x 1 in.
14
2
3
Figure 4
1. Mounting plate
2. Bolt 3/8 x 1 in.
5. If the ends of the levers hit against each other, while in
the drive position (Fig 5) (levers rotated in as far as
possible) make adjustments by moving the levers
outwards to the neutral lock position and carefully
bend them outward. Move them back to the drive
position and check for clearance. Repeat if necessary.
Figure 5
Activating the Battery
Bulk electrolyte with 1.260 specific gravity must be
purchased from a local battery supply outlet.
1. Remove the battery from the machine.
Important
Be careful not to damage the long vent
tube when removing the battery box.
1
m–3751
3. Spring washer 3/8
Advertisement
Table of Contents
