Set Up
Loose Parts
Note: Use the chart below to verify all parts have been shipped.
Description
Rear Wheels
Retaining rod
Bolt 5/16-18 x 1 (26 mm)
Locknut 5/16
Control lever–right
Control lever–left
Bolt 3/8-1 x 1 (26 mm)
Spring washer 3/8
Key
Operator's Manual
Engine Operator's Manual
Parts Catalog
Registration card
Installing Drive Wheels
1. Uncrate mower.
1. Remove wheel bolts or nuts from rear wheel hubs.
2. Align holes. Mount drive wheels with the valve stem
to the outside of the traction unit.
3. Secure using wheel bolts or nuts provided. Torque to
95 ft-lbs (128 N M).
Checking Tire Pressure
Pressure: 13 psi (90 kPa)
1. Check the air pressure in the front and rear tires
(Fig. 2).
Qty.
Use
2
Installing wheels to traction unit
1
1
Installing seat rod
1
1
1
Installing motion control levers
4
4
2
1
Read before operating machine
1
1
1
Fill out and return to Toro
1. Valve stem
Installing Seat Retaining Rod
1. Tilt seat up. Remove locknut (5/16 in.) from bolt
attaching seat retaining rod to seat frame (Fig. 3).
13
1
m–1872
Figure 2