Installing The Motion Control Levers; Adding Fuel To The Machine; Charging The Battery - Toro Z400 Series Z-Master Setup Instructions

Step
6
Installing the Motion
Control Levers
Parts needed for this step:
1 Right control lever
1 Left control lever
4 Bolt (3/8 x 1 inch) (2 are assembled)
4 Curved washer (3/8 inch) (2 are assembled)
Procedure
Step
7

Adding Fuel to the Machine

No Parts Required
Procedure
Add fuel to the machine before starting it. Refer
to your Operator's Manual. for the correct fuel and
procedure.
Step
8

Charging the Battery

No Parts Required
Procedure
Charging the battery produces gasses that
can explode and cause serious injury.
• Keep cigarettes, sparks and flames away
from the battery.
• Make sure the ignition switch is off.
• Ventilate when charging or using the
battery in an enclosed space.
Important: Do not run the machine with
the battery disconnected; electrical damage
may occur to the engine.
Charge the battery. Refer to the Operator's Manual
for instructions.
Figure 14
6