Installing The Motion Control Levers - Toro timecutter series Setup Instructions

3. Secure the seat to the seat support with the
spacers, flat washers (5/16 inch) and knobs
(Figure 6).
Figure 6
1. Seat
2. Seat support
3. Knob
Important: Make sure the spacers
are between the seat and support, and
the knobs pass through the washers,
seat support, spacers and into the seat
(Figure 6).
4. Connect the seat switch harness to the seat
switch in the base of the seat as shown in
Figure 7.
Figure 7
1. Seat
2. Seat switch
5. Lower the seat and adjust it if necessary; refer
to Positioning the Seat in the mower Operator's
Manual.
4. Washers (5/16 inch)
5. Spacer
3. Switch harness
Step
4
Installing the Motion
Control Levers
Parts needed for this step:
2 Control lever
4
Bolt (1/4 x 3/4 inch)
Procedure
1. Remove the motion control levers from the
machine.
2. Position the control lever to the desired height
and align with the holes in the control lever
shaft (Figure 8).
3. Install 2 bolts (1/4 x 3/4 inch) into the control
lever and shaft (Figure 8).
Figure 8
1. Control lever
2. Bolt
4. Repeat the installation for the opposite control
lever.
5. Lower the seat and adjust if necessary; refer to
Positioning the Seat in the Operator's Manual.
4
3.