Installing The Motion Control Levers - Toro Z Master G3 Setup Instruction

8
Installing the Motion Control
Levers
Parts needed for this procedure:
1 Right control lever
1 Left control lever
4 Bolt (3/8 x 1 inch) (2 are assembled)
4
Nut (3/8 inch) (2 are assembled)
Procedure
1. Rotate the motion control levers to the upright
position.
2. Loosely install the control levers on the outside of
the posts, using 4 bolts and 4 nuts.
Note: Install the control levers in the top and
middle holes for the high position or the middle and
bottom holes for the low position, as desired.
Figure 12
1. Bolt (3/8 x 1 inch)
2. Handle
3. Raise the levers and align them together in the
neutral position and tighten the bolts.
3. Control lever
4. Nut (3/8 inch)
Note: If the machine is not properly tracking, refer
to Adjusting the Tracking in your Operator's Manual.
9
Installing the Lift Assist Pedal
Parts needed for this procedure:
1 Carriage bolt (3/8 x 1-1/2 inches)
1 Flange locknut (3/8 inch)
Procedure
1. If needed, loosen the existing bolt and nut for the
lift assist pedal.
2. Rotate the lift assist pedal to the correct position
and install the carriage bolt (3/8 x 1-1/2 inches) and
locknut (3/8 inch) (Figure 14). Tighten both bolts.
6
Figure 13