Table of Contents
Advertisement
Installing the Seat Retaining
Rod
1. Tilt seat up. Remove the locknut (5/16 inch) from bolt
attaching seat retaining rod to seat frame (Fig. 3).
2. Remove retaining rod from seat and insert the L
shaped end of the rod into the hole directly above the
left–side hydraulic pump (Fig. 3).
3. Place the seat retaining rod to the outside of the seat
mounting tab and secure with a bolt (5/16 x 1 inch)
and locknut (5/16 inch) (Fig. 3).
4. Tighten nut until snug, then loosen so the rod pivots
freely.
4
2
Figure 3
1. L end of retaining rod
2. Locknut, 5/16 inch
Installing the Motion Control
Levers
There are two positions to install the control levers, high
and low. Install levers in the top and middle holes for the
high position. Install levers in the middle and bottom
holes for the low position.
1. Remove the 4 bolts (3/8 x 1 inch) and 4 spring washers
(3/8 inch) which attach the motion control levers to the
control arm shafts for shipping (Fig. 4).
2. Place the levers (with the mounting plate toward the
rear) on the outside of the control arm shaft and secure
with 4 bolts (3/8 x 1 inch) and 4 spring washers
(3/8 inch) (Fig. 4).
1
3
m–5712
3. Bolt, 5/16 x 1 inch
4. Seat mounting tab
16
3. Position the levers so the bolts are in the center of the
slots on the lever mounting plate and tighten until
snug.
4. Align the front\rear position of the levers, with each
other, in the neutral position. Loosen hardware and
adjustment by sliding/tilting the lever(s) forward or
backward until properly aligned(Fig. 4).
2
1
3
Figure 4
1. Mounting plate
2. Bolt, 3/8 x 1 inch
3. Spring washer, 3/8 inch
5. If the ends of the levers hit against each other, while in
the drive position (Fig 5) (levers rotated in as far as
possible) make adjustments by moving the levers
outward to the neutral lock position and carefully bend
them outward. Move them back to the drive position
and check for clearance. Repeat if necessary.
FRONT
OF
UNIT
LEVERS IN
ALIGNMENT
Figure 5
Installing the Grass Deflector
The grass deflector is used when in side discharge mode
only.
4
5
6
m–5596
4. Top hole
5. Middle hole
6. Bottom hole
Advertisement
Table of Contents
