Operation; Think Safety First - Toro 74920 Operator's Manual

Height-of-Cut Lever
The height-of-cut lever works with the foot pedal to
lock the deck in a specific cutting height. Only adjust the
height of cut while machine is not moving (Figure 4).
Attachments/Accessories
A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.

Operation

Note: Determine the left and right sides of the
machine from the normal operating position.

Think Safety First

Please carefully read all of the safety instructions and
decals in the safety section. Knowing this information
could help you, your family, pets or bystanders avoid
injury.
DANGER
Mowing on wet grass or steep slopes can cause
sliding and loss of control.
Wheels dropping over edges can cause rollovers,
which may result in serious injury, death or
drowning.
A loss of traction is a loss of steering control.
To avoid loss of control and possibility of rollover:
• Do not mow near drop-offs or near water.
• Do not mow slopes greater than 15 degrees.
• Reduce speed and use extreme caution on
slopes.
• When mowing slopes, gradually work from
lower to higher areas on the incline.
• Avoid sudden turns or rapid speed changes.
• Turn up, into an incline when changing
directions on slopes. Turning down the slope
reduces traction.
• Attachments change the handling
characteristics of the machine. Use
extra caution when using attachments with the
machine.
18