Toro 74920 Operator's Manual page 31

locknut on the side wall of the mower deck securing
the left baffle to the deck.
4
Figure 36
1. Locknut (5/16 inch)
2. Carriage bolt (5/16 x 3/4
inch)
7. Remove the left baffle from the mower deck as
shown in Figure 36.
8. Locate the two bolts in loose parts and use the
existing locknuts. Install these fasteners into the
holes shown in Figure 36 on the mower deck to
prevent flying debris. Install the bolt up, through the
underside of the deck and use an existing locknut to
secure from the topside.
WARNING
Open holes in the mower expose you and others
to thrown debris which can cause severe injury.
• Never operate the mower without hardware
mounted in all holes in the mower housing.
• Install the hardware in the mounting holes
when you remove the mulching baffle.
9. Remove the carriage bolt (5/16 x 3/4 inch) and
locknut (5/16 inch) on the rear wall of the mower
deck securing the baffle to the deck (Figure 37).
1
2
3
3. Left baffle
4. Install fasteners here
G010712
1
7
G011149
1. Carriage bolt (5/16 x 3/4
inch)
2. Locknuts, front of
discharge plate (reinstall
after baffle is removed)
3. Locknut, forward hole in
deck (reinstall after baffle
is removed)
4. Baffle guard, 54 inch
decks
10. Locate the baffle guard at the front edge of the side
discharge opening. Remove the fasteners securing
the baffle guard and the right baffle to the mower
deck as shown in Figure 37. Remove the baffle
guard and retain all fasteners.
11. Remove the two locknuts (5/16 inch) securing the
welded posts of the right baffle to the top of the
mower deck at center and right of center positions
(Figure 38).
12. Remove the carriage bolt and locknut securing the
right baffle to the top of the mower deck. Remove
the right baffle from the mower deck (Figure 38).
31
2
1
3
5
6
Figure 37
5. Hex head bolt, forward
hole in deck (reinstall after
baffle is removed)
6. Carriage bolts, front of
discharge plate (reinstall
after baffle is removed)
7. Locknut (5/16 inch)
4