Stopping The Machine; Adjusting The Height Of Cut - Toro 74920 Operator's Manual

Figure 24
Driving Backward
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the motion control
levers rearward (Figure 25).
Figure 25

Stopping the Machine

To stop the machine, move the traction control levers
to neutral and move to locked position, disengage the
G008952
G008953
26
blade control switch (PTO), and turn the ignition key
to off.
Set the parking brake when you leave the machine; refer
to Setting the Parking Brake. Remember to remove the
key from the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.

Adjusting the Height of Cut

The machine is equipped with a foot pedal deck lift
system. The operator can use the foot pedal to lift
the deck briefly to avoid obstacles or lock the deck in
the highest height-of-cut or transport position. The
operator can use the height of cut lever with the foot
pedal to lock the deck in a specific cutting height.
Using the Foot Pedal Deck Lift System
Press the pedal down to raise the deck; continue to
press the pedal until the deck is locked in the transport
position Figure 26. Push on the deck lift pedal with
your foot and raise the height-of-cut lever slightly to
disengage the transport lock.
Figure 26
Transport Lock Position
G010219