Seat Adjustments - Toro 02003 Operator's Manual

1
1. Ignition switch
Charge Indicator Light (Fig. 12)—Illuminates when
the charging system malfunctions.
Oil Pressure Light (Fig. 12)—When the oil light is ON,
it indicates the engine oil pressure is low. After the
engine starts, the light should go out. When the engine is
running, the light comes ON if the oil pressure drops
below a safe operating level. If the light comes on while
the engine is running, stop the engine immediately and
correct the cause of low oil pressure.
Coolant Temperature Light (Fig. 12)—The coolant
temperature light shows when the engine cooling system
is overheated.
1
1. Charge indicator light
2. Oil pressure light
3. Coolant temperature light
4. Glow plug indicator light
Glow Plug Indicator Light (Fig. 12)—The glow plug
indicator light comes on when the ignition switch is in
the RUN position but should be out when the engine is
running.
Figure 11
2 3
4
Figure 12

Seat Adjustments

Fore and Aft Adjustment
of the seat outward, slide the seat to the desired position
and release the lever to lock the seat into position.
Deluxe Seat Adjustments (Fig. 13)
Fore and Aft Adjustment
side of the seat assembly outward. Release the handle to
lock the seat position.
Operator Weight Adjustment
clockwise to increase tension, counterclockwise to
decrease tension.
1. Fore and aft lever
2. Weight adjustment lever
Cutting Unit Lock-up Lever
cutting unit in the raised position.
1
1. Cutting unit lock-up lever
2. Seat adjusting screws
(Fig. 15)—Close the fuel valve (located
Fuel Valve
under the fuel tank) when storing the machine.
—Move the lever on the side
—Pull the handle on the left
—Turn the knob
Figure 13
(Fig. 14)—Locks the rear
Figure 14
Controls
2
15