Toro 02003 Operator's Manual page 23

LUBRICATION
GREASING BEARINGS AND BUSHINGS
The traction unit and cutting unit's grease fittings must
be lubricated regularly with No. 2 General Purpose
Lithium Base Grease. If the machine is operated under
normal conditions, lubricate bearings and bushings after
every 25 hours of operation. Bearings and bushings must
be lubricated daily when operating conditions are
extremely dusty and dirty. Dusty and dirty operating
conditions could cause dirt to get into the bearings and
bushings, resulting in accelerated wear. Lubricate grease
fittings immediately after every washing, regardless of
the interval listed.
The traction unit bearings and bushings, and the cutting
unit lubrication points that must be lubricated are shown
in the photos and illustrations.
Figure 19
Figure 20
Maintenance
Figure 21
Figure 22
Figure 23
Figure 24
23