Table of Contents
Advertisement
damage from short outs whenever working with the
electrical system.
Storing the Battery
If the machine will be stored more than 30 days, remove
the battery and charge it fully. Either store it on the shelf
or on the machine. Leave the cables disconnected if they
are stored on the machine. Store the battery in a cool
atmosphere to avoid quick deterioration of the charge in
the battery. To prevent the battery from freezing, ensure
that it is fully charged. The specific gravity of a fully
charged battery is 1.265 – 1.299.
Fuses
The fuses are located under console cover of the
machine.
Drive System
Maintenance
Adjusting the Traction Drive
for Neutral
If the machine moves when the traction pedal is in the
neutral position, adjust the traction cam.
1. Park the machine on a level surface and turn the
engine off.
2. Raise one front wheel and one rear wheel off the
floor and place support blocks under the frame.
Note: One front wheel and rear wheel must be
raised off the ground or the machine will move
during the adjustment.
3. Loosen locknut on traction adjustment cam
(Figure 62).
1. Traction adjustment cam
4. Start the engine and rotate the cam hex in both
directions to determine mid-position of neutral span.
5. Tighten the locknut that secures the adjustment.
6. Stop the engine.
7. Remove the support blocks and lower the machine
to the shop floor. Test drive the machine to ensure
that it does not creep.
46
Figure 62
2. Locknut
Advertisement
Table of Contents
