Lubrication; Greasing The Bearings And Bushings - Toro 03206 Operator's Manual

Lubrication

Greasing the Bearings And
Bushings
Service Interval: Every 50 hours (Lubricate all bearings
and bushings daily when conditions
are dusty and dirty.)
Yearly
Every 500 hours/Yearly (whichever
comes first)
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base
Grease. Bearings and bushings must be lubricated
daily when the operating conditions are extremely
dusty and dirty. Dusty and dirty operating conditions
could cause dirt to get into the bearings and bushings,
resulting in accelerated wear. Lubricate the grease
fittings immediately after every washing, regardless of
the interval specified.
The grease fitting locations and quantities are as follows:
• Rear cutting unit pivot (Figure 44)
Figure 44
• Front cutting unit pivot (Figure 45)
Figure 45
• SideWinder cylinder ends (2; model 03206 only)
(Figure 46)
• Steering pivot (Figure 47)
• Rear lift arm pivot and lift cylinder (2) (Figure 48)
39
Figure 46
Figure 47