Final Installation; Door Replacement And Adjustment - Viking D3 Installation Manual

Final Installation

1
Slide range into place. Be sure
anti-tip bracket slides into the anti-tip opening.
3
" " "
3 / 8 3 / 8 3 / 8
) ) )
c m c m c m
9 5 9 5 9 5
( 0 . ( 0 . ( 0 .
Check that unit is level side to side
and front to back. The side trim must be 3/8" (0.95 cm)
above countertop. If unit is not level, repeat Steps 5-7
in "Leveling/Adjustments/Alignment" section.
18
2
Burner heads and burner caps are packed in the
cardboard top pack with the grates. Align burner head
on burner base. Place burner cap on burner head.
Place grate onto the burner pan.

Door Replacement and Adjustment

1
Reattach door to range.
3
Remove pins from holes in hinges.
5
If the door needs to be adjusted, loosen hinge trim screws
located in step 2. Adjust the screws located between the
door and kickplate using a 5/32" hex head Allen wrench.
After adjustment, tighten hinge trim screws.
19
2
1
Open door completely. Reattach hinge trim on both
sides.
4
Close door.