Table of Contents
Advertisement
Connecting Gas & Electric
DANGER
GAS LEAK HAZARD
To avoid risk of personal injury or
death; leak testing of the appliance
must be conducted according to
the manufacturer's instructions. Before
placing appliance in operation, always check
for gas leaks with soapy water solution.
• DO NOT USE AN OPEN FLAME TO
CHECK FOR GAS LEAKS.
1
Connect gas and electrical. Before placing appliance in operation,
always check for gas leaks. This must be performed by your
dealer, a qualified licensed plumber, or gas service company.
2
Burner heads and burner caps are packed in the
cardboard top pack with the grates. Align burner head
on burner base. Place burner cap on burner head.
Place grate onto the burner pan.
Note: Refer to electrical and gas
requirements section for proper
installation information.
Final Installation
1
Slide range into place. Be sure
anti-tip bracket slides into the anti-tip opening.
3
Check that unit is level side to side
and front to back. The side trim must be 3/8" (0.95 cm)
above countertop. If unit is not level repeat Steps 5-7
of "Leveling/Adjustments/Alignment" section.
23
"
"
"
3 / 8
3 / 8
3 / 8
)
)
)
c m
c m
c m
9 5
9 5
9 5
( 0 .
( 0 .
( 0 .
Advertisement
Table of Contents
