Anti-Tip Device Installation; Connecting Gas & Electrical - Viking D3 Installation Manual

Leveling/Adjustments/Alignments
7
Set the high corner of range so that the top of side trim is
3/8" (0.95 cm) above countertop. Level range to high corner.

Anti-tip Device Installation

WARNING
TIPPING HAZARD
To reduce the risk of property
damage or personal injury;
install anti-tipping device
provided in accordance with
the installation instructions
in this document. Device
must be engaged properly to
prevent product from tipping
over.
2
7 - 3 7 - 3 7 - 3
/ 1 / 1 / 1
( 1 8 ( 1 8 ( 1 8
6 " 6 " 6 "
. 3 . 3 . 3
c m c m c m
) ) )
) ) )
( A ( A ( A
n t n t n t
m e m e m e m ) m ) m )
u r e u r e u r e 4 c 4 c 4 c
a s a s a s ( . 6 ( . 6 ( . 6
M e M e M e / 4 " / 4 " / 4 "
+ 1 + 1 + 1
Locate anti-tip bracket on rear wall with the top left corner at
measurement (A) plus 1/4" (.64 cm) from the floor and 22-1/4" (56.5 cm)
from where the right side of range (facing range) is to be located.
(cont.)
1
M e
a s
u r e
m e
n t
( A
)
Measure from floor to bottom
of the anti-tip opening located on the back of range.
This will be measurement (A).
3
Mark and drill holes where bracket will be located.
16
Anti-tip Device Installation
4
Attach bracket with
mounting hardware provided.
Connecting Gas & Electric
DANGER
GAS LEAK HAZARD
To avoid risk of personal injury
or death; leak testing of the
appliance must be conducted
according to the manufacturer's
instructions. Before placing appliance in
operation, always check for gas leaks
with soapy water solution.
• DO NOT USE AN OPEN FLAME TO
CHECK FOR GAS LEAKS.
1
Connect gas and electrical. Before placing appliance in operation,
always check for gas leaks. This must be performed by your
dealer, a qualified licensed plumber, or gas service company.
17
(cont.)
Note: Refer to electrical and gas
requirements section for proper
installation information.