Connecting Gas & Electric
WARNING
GAS LEAK HAZARD
To avoid risk of personal
injury or death; leak testing
of the appliance must be
conducted according to the
manufacturer's instructions. Before
placing appliance in operation, always
check for gas leaks with soapy water
solution.
• DO NOT USE AN OPEN FLAME TO CHECK
FOR GAS LEAKS
Final Installation
1
Slide range into place. Be sure
wall anti-tip bracket slides into the
anti-tip opening or fl oor anti-tip
hook and bracket are engaged
(depending on the one used)
Door Replacement and Adjustment
1
Carefully realign door on hinges.
Slide in and down.
Note: Refer to electrical and gas
requirements section for proper
installation information.
2
Burner caps and burner bowls are
packed in top pack with the grates.
Place burner bowl in grate support
and burner cap on top of burner.
Place burner grate over burner cap
and on top of grate support.
2
Open door completely.
Fold latches forward until locked
in place
14
1
Connect gas and electrical. Before placing
appliance in operation, always check for
gas leaks. This must be performed by your
dealer, a qualifi ed licensed plumber, or gas
service company.
3
Check that unit is level side to side
and front to back. The side trim must be
3/8" (0.95 cm) above countertop. If unit
is not level repeat steps 5-7 of "Leveling/
Adjustments/Alignment" section.
3
Close door
"
"
"
3 / 8
3 / 8
3 / 8
)
)
)
c m
c m
c m
9 5
9 5
9 5
( 0 .
( 0 .
( 0 .