Standoff Spacer Removal; Final Installation - Viking VGR7362 Installation Manual

Installation - Ranges

Standoff Spacer Removal

DANGER
FIRE HAZARD
Backguards come standard with
standoff spacers which provide a barrier
between back of range and rear wall. These
must be in place for adequate ventilation.
Standoff spacers can only be removed if
range is installed against a Non-
Combustible wall.

Final Installation

1
Slide range into place. Be sure
wall anit-tip bracket slides into the anit-tip opening and
floor anti-tip hook and bracket are engaged.
2
Burner heads and bases are packed in cardboard top pack with
the grates. Place burner bases on top of the burner flanges and
burner heads on top of the burner base. Place burner grate on
top of grate support. (See "Proper alignment of Burner Head".)
1a
3
Check that unit is level side to side
and front to back. The side trim must be 3/8" (0.95 cm) above
countertop. If unit is not level repeat Steps 5-7 of
"Leveling/Adjustments/Alignment" section.
24
" " "
3 / 8 3 / 8 3 / 8
) ) )
c m c m c m
9 5 9 5 9 5
( 0 . ( 0 . ( 0 .