Saving A Program - Vox Dynamic Looper Owner's Manual

VOX Dynamic Looper Owner's manual

Saving a program

The PRE FX TARGET setting (the choice of input to which
the Pre Effect will apply), the Pre Effect that modifies the
sound of your guitar, the Loop Effect that modifies the loop
phrase(s) being played back, and the control pedal
assignment are saved together as a program.
If you've edited the contents of a program, and then
selected another program or turned off the power before
saving the modified program, the settings that you
edited will return to their original state. If you want to
keep the changes that you made, you must save the
program as follows.
1. Press the WRITE button.
The indication in the program/value display will blink. If
you were editing a preset program, a user program
number will appear.
2. Use the EDIT knob to specify the writing-destination
user program.
Your program will be saved by overwriting the
destination program that you specified. Take care not to
overwrite an important program that you want to keep.
It's not possible to save your program to a preset program.
3. Press the WRITE button once again.
Your new program will overwrite the user program you
specified in step 2, and the program/value display will
change back from blinking to steadily lit.
38
Note: When you write a program, the Dynamic Looper
will be in the same state as immediately after you selected
the writing-destination program. If you wrote the
program while using the control pedal to control the Loop
Effect, the Loop Effect will be temporarily disabled.