Product Overview; Controls - Toro 74915 Z Master G3 Operator's Manual

Product Overview

1. Height-of-cut deck lift
pedal
2. Transport lock
3. Parking brake lever

4. Controls

5. Motion control levers
Controls
Become familiar with all the controls before you start the
engine and operate the machine (Figure 4 and Figure 5).
2
1
6
1. PTO Switch
2. Choke
3. Throttle control
Hour Meter
The hour meter records the number of hours the engine
has operated. It operates when the engine is running.
Use these times for scheduling regular maintenance
(Figure 6).
Figure 4
6. Roll bar
7. Seat belt
8. Fuel cap
9. Mower deck
10. Caster wheel
3
4
Figure 5
4. Hour meter/Safety
interlock display
5. Ignition switch
6. Fuses
Fuel Gauge
The fuel gauge is located with the hour meter and the
bars light up when the ignition switch is on (Figure 6).
The indicator light appears when the fuel level is low
(approximately one gallon remaining in the fuel tank).
Safety Interlock Indicators
There are symbols on the hour meter and the indicate
with a black triangle that the interlock component is in
the correct position (Figure 6).
Battery Indicator Light
If the ignition key is turned to the On position for a few
seconds, the battery voltage will be displayed in the area
where the hours are normally displayed.
The battery light turns on when the ignition is turned
on and when the charge is below the correct operating
level (Figure 6).
5
G008950
1. Fuel gauge (bars)
2. Battery light
3. Hour meter
Throttle Control
G008951
The throttle control is variable between Fast and Slow.
Choke
Use the choke to start a cold engine. Pull the choke
knob up to engage it.
Blade Control Switch (PTO)
The blade control switch (PTO) is used to engage the
electric clutch and drive the mower blades. Pull the
switch up to engage the blades and release. To disengage
12
1 2
Figure 6
4. Safety interlock symbols
5. Low fuel indicator light
3
4