Fuel System Maintenance; Replacing The Fuel Filter; Servicing The Fuel Tank - Toro 74915 Z Master G3 Operator's Manual

Fuel System
Maintenance

Replacing the Fuel Filter

Service Interval: Every 500 hours/Yearly (whichever
comes first) (more often in dirty or
dusty conditions).
The fuel filter is located near the engine on the front
or rear side of the engine.
1. Disengage the PTO, move the motion control levers
to the neutral locked position, and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Allow the machine to cool down.
4. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
5. Close the fuel shutoff valve under the seat
(Figure 55).
Figure 55
1. Fuel filter
2. Hose clamp
6. Squeeze the ends of the hose clamps together and
slide them away from the filter (Figure 55).
7. Remove the filter from the fuel lines.
8. Install a new filter and move the hose clamps close
to the filter (Figure 55).
9. Open the fuel shutoff valve.
Note: It is important to reinstall the fuel line hoses and
secure with plastic ties the same as they were originally
3. Fuel shutoff valve
installed at the factory to keep the fuel line away from
components that can cause fuel line damage.

Servicing the Fuel Tank

Do not attempt to drain the fuel tank. Ensure that an
Authorized Service Dealer drains the fuel tank and
services any components of the fuel system.
39