Servicing The Fuses; Drive System Maintenance; Checking The Seat Belt; Checking The Rollover Protection System (Rops) Knobs - Toro 74915 Z Master G3 Operator's Manual

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check the
component/circuit for a malfunction or short.
1. The fuses are located on right hand console next to
the seat (Figure 58).
2. To replace the fuses, pull out on the fuse to remove
it.
3. Install a new fuse (Figure 58).
Figure 58
1. Optional accesory-15 amp 4. Main-25amp
2. Charge-25amp
3. PTO-10amp
5. Console
Drive System
Maintenance

Checking the Seat Belt

Service Interval: Before each use or daily
Visually inspect seat belt for wear, cuts, and proper
operation of retractor and buckle. Replace before
operating if damaged.
Checking the Rollover
Protection System (ROPS)
Knobs
Service Interval: Before each use or daily
Check that both the mounting hardware and the knobs
are in good working condition. Make sure the knobs
are fully engaged with the ROPS in the raised position.
The upper hoop of the roll bar may need to be pushed
forward or pulled rearward to get both knobs fully
engaged.
42