Operating The Ignition Switch; Using The Fuel Shut-Off Valve; Starting And Stopping The Engine - Toro 74915 Z Master G3 Operator's Manual

1
2
Figure 16
1. On

Operating the Ignition Switch

1. Turn the ignition key to the Start position
(Figure 17). When the engines starts, release the key.
Important: Do not engage starter for more
than 5 seconds at a time. If the engine fails
to start allow a 15 second cool-down period
between attempts. Failure to follow these
instructions can burn out the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the
fuel system has been without fuel completely.
Figure 17
2. Turn the ignition key to stop to stop the engine.

Using the Fuel Shut-Off Valve

The fuel shut-off valve is located under the seat.
G008959
2. Off
G008947
Close the fuel shut-off valve for transport, maintenance,
and storage.
Ensure the fuel shut-off valve is open when starting
the engine.
1. On
2. Off
Starting and Stopping the
Engine
Starting the Engine
1. Raise the ROPS up and lock into place, sit on the
seat and fasten the seat belt.
2. Move the motion controls to neutral locked
position.
3. Set the parking brake; refer to Setting the Parking
Brake.
4. Move the blade control switch (PTO) to the Off
position (Figure 19).
5. Move the throttle lever midway between the Slow
and Fast positions.
19
Figure 18
3. Hose going to the engine