Replacing The Grass Deflector - Toro 74915 Z Master G3 Operator's Manual

1. Right stabilizer
2. Deck strut (right side shown)
3. Remove the rear deck lift attachment shoulder bolt and nut.
4. Remove the front deck lift attachment shoulder bolt and nut.
8. Raise the deck struts and secure them in the up
position. Slide the deck out to the right side of the
machine.

Replacing the Grass Deflector

WARNING
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator's or
bystander's direction and result in serious injury.
Also, contact with the blade could occur.
• Never operate the lawn mower unless you install
a cover plate, a mulch plate, or a grass chute and
catcher.
• Make sure the grass deflector is in the down
position.
1. Remove the locknut, bolt, spring and spacer holding
the deflector to the pivot brackets (Figure 99).
Remove the damaged or worn grass deflector.
2. Place the spacer and spring onto grass deflector.
Place the L end of spring behind deck edge.
Figure 98
Note: Make sure the L end of the spring is installed
behind the deck edge before installing the bolt as
shown in Figure 99.
3. Install the bolt and nut. Place the J hook end of the
spring around the grass deflector (Figure 99).
Important: The grass deflector must be able to
lower down into position. Lift the deflector up
to test that it lowers into the full down position.
1. Bolt
2. Spacer
3. Locknut
4. Spring
61
Figure 99
5. Spring installed
6. Grass Deflector
7. L end of spring, place
behind deck edge before
installing bolt
8. J hook end of spring