17
SERVICE WORK ON THE ENGINE
–
Place the long oil screen
–
Push the pin wrench through the opening into the drill hole of the opposite engine
case wall and push the engine oil screen as far as possible into the engine case.
C00236-10
–
Mount and tighten screw plug
Guideline
Screw plug, oil screen
–
Mount and tighten the oil drain plug
Guideline
Oil drain plug with magnet
C00069-10
–
Remove screws
C00070-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surface.
C00071-10
–
Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Insert the oil filter into the oil filter housing.
–
Lubricate the O-ring of the oil filter cover and mount it with the oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
C00072-10
–
Remove the oil filler plug
engine oil.
Engine oil
Info
Too little engine oil or poor-quality engine oil results in premature wear to
the engine.
–
Install and tighten the oil filler plug with O-ring.
601828-10
4
with the O-rings onto a pin wrench.
3
with the O-ring.
1
5
. Remove the oil filter cover with the O-ring.
6
out of the oil filter housing.
8
with the O-ring from the clutch cover and fill up with
1.50 l (1.59 qt.)
M20x1.5
15 Nm
(11.1 lbf ft)
with the magnet and a new seal ring.
M12x1.5
20 Nm
(14.8 lbf ft)
M5
6 Nm (4.4 lbf ft)
Engine oil (SAE 10W/50) (
84
7
.
p. 100)