14
ELECTRICAL SYSTEM
14.11
Changing the turn signal bulb
Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
–
Remove the screw on the rear of the turn signal housing.
–
Remove turn signal glass
–
Press the bulb carefully into the socket, turn it counterclockwise by about 30°, and pull
it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new bulb carefully into the socket and turn it clockwise all the way.
M00678-10
Turn signal (RY10W / socket BAU15s) (
–
Position the turn signal glass.
–
Insert the screw and turn it counterclockwise first until it engages in the thread with a
light jerk. Tighten the screw slightly.
–
Check that the turn signal system is functioning properly.
.
p. 161)
120