KTM 690 Duke Owner's Manual page 78

11 SERVICE WORK ON THE CHASSIS
Main work
–
Loosen nut
–
Loosen nuts
–
Adjust the chain tension by turning adjusting screws
Guideline
Chain tension
Turn adjusting screws
right chain adjusters
rear wheel is then correctly aligned.
Info
The upper part of the chain must be taut.
Chain wear is not always even. Repeat this measurement at different chain posi-
tions.
–
Tighten nuts
–
Make sure that chain adjusters
–
Tighten nut
M00660-10
Guideline
Nut, rear wheel spindle

.
 .

on the left and right so that the markings on the left and

are in the same position relative to reference marks

.

are fitted correctly on adjusting screws

.

left and right.
5 mm (0.2 in)
M25x1.5 90 Nm
(66.4 lbf ft)
76

. The

.