16
ELECTRICAL SYSTEM
16.11
Changing the turn signal bulb
Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
–
Install the mask spoiler.
–
Install the tank cover. (
–
Install the front side cover. (
–
Mount the seat. (
–
Check the headlight setting. (
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove diffuser
–
Press bulb
it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new bulb carefully into the socket and turn it clockwise until it stops.
M00948-10
Turn signal (RY10W / socket BAU15s) (
–
Check the turn signal to make sure it is functioning properly.
–
Position the diffuser.
(
p. 114)
p. 119)
p. 110)
p. 97)
p. 164)
.
carefully into the socket, turn it counterclockwise by about 30°, and pull
p. 200)
163