13
SERVICE WORK ON THE CHASSIS
Preparatory work
–
Lift the motorcycle with the rear lifting gear. (
–
Check the chain tension. (
Main work
–
Loosen nut
–
Loosen nuts
–
Adjust the chain tension by turning the adjusting screws
Guideline
Chain tension
Turn the adjusting screws
left and right chain adjusters
marks
Info
The upper part of the chain must be taut.
Chain wear is not always even, so you should check the setting at different chain
positions.
–
Tighten nuts
–
Make sure that chain adjusters
–
Tighten nut
M00890-10
Guideline
Nut, rear wheel spindle
Info
Chain adjusters
p. 99)
.
.
on the left and right so that the markings on the
are in the same position relative to the reference
. The rear wheel is then correctly aligned.
.
are fitted correctly on adjusting screws
.
M25x1.5
can be turned by 180°.
p. 92)
left and right.
40... 45 mm (1.57... 1.77 in)
90 Nm
Thread greased
(66.4 lbf ft)
101
.