KTM 1050 Adventure Owner's Manual page 106

13 SERVICE WORK ON THE CHASSIS
–
Check the chain sliding guard for wear at the recess.
Info
When the chain sliding guard is new, the rivets
edge
» When the rivets of the chain are no longer visible at the bottom edge of the recess
of the chain sliding guard:
–
Change the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
M00891-10
» If the chain sliding guard is loose:
–
Tighten the screws on the chain sliding guard.
Guideline
Screw, chain sliding guard
–
Check the chain guide for wear.
» If the chain guide is worn:
–
Change the chain guide.
–
Check that the chain guide is firmly seated.
» If the chain guide is loose:
–
Tighten the screws on the chain guide.
Guideline
Screw, chain guide
401670-01
Finishing work
–
Remove the rear of the motorcycle from the lifting gear. (

of the recess.

are half visible at the bottom
M5 5 Nm (3.7 lbf ft)
M6 5 Nm (3.7 lbf ft)
p. 92)
104