Maintenance Work On The Engine; Checking The Gear Oil Level; Changing The Gear Oil; Draining The Gear Oil - KTM 65 SX Owner's Manual

MAINTENANCE WORK ON THE ENGINE

Checking the gear oil level

15.1
Info
The gear oil level must be checked when the engine is cold.

Changing the gear oil

x
15.2

Draining the gear oil

x
15.3
Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the gear oil only when the engine is warm.
–
Stand the motorcycle upright on a horizontal surface.
–
Remove gear oil level check screw
–
Check the gear oil level.
A small amount of gear oil should flow out of the hole.
» If no gear oil flows out:
–
Add gear oil.
–
Mount and tighten the gear oil level check screw.
Guideline
Screw, gear oil level check
300661-10
–
Drain the gear oil.
400721-01
–
Fill up with gear oil.
400722-01
–
Stand the motorcycle on its side stand on a horizontal surface.
.

( p. 68)
x
M6
( p. 67)
x
x ( p. 68)
67
6 Nm (4.4 lbf ft)