Table of Contents
Advertisement
button or user input manual reset, serial reset command or meter power
cycle. When the user input or
the corresponding "on" output is reset immediately and remains off until the
trigger point is crossed again. (Previously latched alarms will be off if power
up Display Value is lower than setpoint value.)
= Latch with delay reset action; This action latches the output on at the
L-dLY
trigger point per the Setpoint Action shown in Setpoint Output Figures. Latch
means that the output can only be turned off by the front panel
or user input manual reset, serial reset command or meter power cycle. When
the user input or
button is activated (momentary action), the meter
RST
delays the event until the corresponding "on" output crosses the trigger off
point. (Previously latched outputs are off if power up Display Value is lower
than setpoint value. During a power cycle, the meter erases a previous
reset if it is not activated at power up.)
Setpoint Output Reset Actions
6.5 MODULE 5 - S
The Serial Setup Parameters are only active when the optional RS232 or RS485 serial communications module is installed in the meter. Refer to the DP6-COM
bulletin for complete details on DP63000 serial communications.
button is activated (momentary action),
RST
RST
S
ERIAL
PARAMETER MENU
OUTPUT RESET WITH DISPLAY RESET
rEn-n
YES
This parameter enables the
the display is reset.
button
Note: For this parameter to operate, the
must be set to
dSP
not met, the output will not reset.
L-dLY
Stb-n
NO
When
, the output is disabled (after a power up) until the trigger point is
YES
crossed. Once the output is on, the output operates normally per the Setpoint
Action and Output Reset Action.
CHANGE DISPLAY COLOR w/OUTPUT STATE
ChC-n
NO
This parameter enables the backlight DP63000B-I to switch the backlight color
when the output state changes. This parameter is only active for the backlight
version.
P
ETUP
ARAMETERS
13
NO
YES
button or user input to reset the output when
RST
button or User Input being used
RST
and the Input value must be displayed. If these conditions are
STANDBY OPERATION
NO
YES
NO
YES
(
)
5-S S Er
Advertisement
Table of Contents
