MAINTENANCE WORK ON FRAME AND ENGINE
Changing the turn signal bulb
9.58
Note
Damage to reflector Reduced luminance.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
–
Remove the headlight mask with the headlight. (
–
Pull socket
–
Insert the new bulb into the socket and insert the socket into the headlight.
Parking light (W5W / socket W2.1x9.5d) (
–
Install the headlight mask with the headlight. (
100596-10
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove diffuser
–
Press bulb
it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new bulb carefully into the socket and turn it clockwise until it stops.
100597-10
out of the headlight and pull bulb
.
carefully into the socket, turn it counterclockwise by about 30°, and pull
p. 125)
out of the socket.
p. 190)
p. 126)
129