12
SERVICE WORK ON THE CHASSIS
12.14
Adjusting the basic position of the clutch lever
Info
Turn the adjusting screw clockwise to increase the distance between the clutch lever and the handlebar.
Turn the adjusting screw counterclockwise to decrease the distance between the clutch lever and the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply force.
Do not make any adjustments while riding!
–
Check the chain sliding guard for wear.
»
If in area
–
Replace the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
»
If the chain sliding guard is loose:
–
Tighten the screw of the chain sliding guard.
Guideline
Screw, chain sliding
K00378-10
guard
Finishing work
–
Remove the rear of the motorcycle from the lifting gear. (
by the chain sliding guard screw
M6
is visible from above:
10 Nm
Loctite
®
243™
(7.4 lbf ft)
p. 83)
95