Instrument Panel; Fuel Gauge; Tachometer; Engine Oil Pressure Light - Cub Cadet 7000 series Manual

M. Instrument Panel
2

1. Fuel Gauge

The fuel gauge monitors, at 20 second intervals,
the fuel level in the fuel tank. The needle pointing to
the right indicates a full tank. The ignition switch
must be in the ON position to read the fuel gauge.

2. Tachometer

The tachometer shows the engine speed in revolu-
tions per minute (RPM). Optimal engine operating
speed is approximately 2500-3600 RPM. When
operating PTO driven attachments the RPM indica-
tor needle should be within the green range on the
tachometer dial.
3. Battery Indicator Light
The bulb illuminates to indicate the battery is being
discharged. If this warning lamp comes on during
operation, check the charging system for possible
causes and/or contact your Cub Cadet dealer.

4. Engine Oil Pressure Light

This warning lamp indicates low engine oil pres-
sure. If the bulb comes on while the engine is
running, stop the engine immediately and check for
possible causes. NOTE: The bulb may illuminate
when the ignition switch is in the ON position, but
should turn off when the engine is started .
5. Engine Coolant Temperature Light
Illumination of this warning lamp indicates the
engine coolant temperature has risen above the
prescribed operating range. If the light comes on
while operating the tractor, eliminate all loads and
try cooling the engine by running at mid throttle for
a few minutes. Stop the engine and allow to cool;
then check for possible causes (e.g. low coolant
level, plugged radiator screen).
6. Parking Brake Indicator Light
The bulb illuminates when the ignition switch is in
the ON position and the brake pedal is depressed.
The light flashes if attempting to start the tractor
with the brake not engaged.
7 4
3
12
10
8
6
Figure 10
15
9
5
10
11
7. PTO Indicator Light
Light comes on in a fixed mode whenever the PTO
switch is in the ON position, with the following
exceptions.
• The light will illuminate in a flashing mode if
attempting to start the tractor with the PTO
switch in the ON position.
• The light will change to the flashing mode when
the PTO switch is on, but the reverse pedal has
been engaged and the reverse override has
NOT been engaged.
8. Hour Meter
The hour meter records the hours and tenths of an
hour ( right most digit) that the tractor has been
operated. The hourmeter is activated whenever the
tractor engine is running. Keep a record of the
hours of operation and maintenance performed to
ensure all maintenance procedures are completed
according to the schedule in this manual.
9. PTO Reverse Override Indicator
This warning lamp illuminates to indicate the PTO
reverse override switch has been depressed and
the PTO reverse override is engaged. Use extra
caution when operating PTO driven attachments
while traveling in the reverse direction.
10. Hazard Light Indicator
Arrows will flash in conjunction with the amber hazard
lights when the hazard light switch is turned on.
11. Glow Plug Indicator Light
Illuminates when the ignition switch is turned to the
ON position. The light remains lit for a preset time
while the glow plugs heat the precombustion
chambers of the diesel engine.
12. Cruise Control Indicator Light (Optional)
1