Panasonic AJ-SPX800P Operating Instructions Manual page 50

Information Item
Gain value
System information
and warnings
Voice memo
indication
Audio input channel
and level meter
Time code indication
DV format indication
Iris override
indication
Iris, F value
Zoom indication
INTERVAL REC/PRE
RECORDING
indication
ID record indication
Downloaded From VideoCamera-Manual.com Manuals
50
Indication
dB
SYSTEM ERROR-
TURN POWER OFF
REC WARNING
BACKUP BATT EMPTY
WIRELESS-RF
EOM
BOS
EOS
CANNOT REC
CANNOT PLAY
COMM ERROR
VOICE CANNOT REC
VOICE REC
VOICE OFF
VOICE PLAY
MARK ON/OFF
UPDATING
USB DRIVE
THUMBNAIL OPEN
1394 INITIAL ERROR
PROXY REC P2&SD
PROXY REC P2
EOM (SD)
PROXY CARD ERROR
SD CARD WRITE ERR
V
- - - - - - - - +
F
W
R
TCG 12:59:59:20
TCR 12:59:59:20
(V)UBG AB CD EF 00
(V)UBR 12 34 56 78
CTL –1:59:59:20
DV
+ +
+
(No indication)
–
– –
NC
OPEN
F1.7 - F16
CLOSE
Z00 - Z99
i
iREC (blink)
iREC (blink) h m/ s
P-REC (blink)
ID
Current gain value.
Something abnormal is happening to the internal computer communications or
reference signal. No further recording or playback can be performed.
replaced with an error code.For more information, see [7-3-2 Error Codes].
P2 card has been removed while being accessed (recorded, played back, or
formatted), and subsequent operation is disabled.
Something abnormal is happening to video and/or audio being recorded.
Backup battery needs replacing.
RF signal from the wireless receiver is degraded.
P2 card has no free space.
Playback position is at the start of all the clips.
Playback position is at the end of all the clips.
The P2 card is not recordable. Detailed information is provided on the FUNCTION
screen of MODE CHECK. See the relevant section of the
indication area.
Clip cannot be played back perhaps because no P2 card is loaded, or the P2 card
contains no clips.
Displayed when disconnection between microcomputers continues for a specified
period or longer.
Voice memos cannot be recorded, possibly perhaps because the P2 card has no
free space, or 100 voice memos are already recorded on one clip.
Voice memo being recorded.
Recording of voice memo stopped.
Voice memo being played back.
Shot mark been added or deleted. For information on shot marks, see [3-10 Shot
Mark Function].
Clip information is being updated. Playback operation disabled.
AJ-SPX800P is in USB mode. When communication is disabled, the indication
blinks.
Thumbnail is being manipulated.
Displayed when the connection of the DVCPRO/DV connector is abnormal (when
AJ-YAD800G is attached).
Displayed when proxy recording on either the P2 card or the SD memory card
starts (when AJ-YAX800G is attached).
Displayed when proxy recording on the P2 card starts (when AJ-YAX800G is
attached.).
Displayed when full capacity is reached during proxy recording on the SD memory
card (when AJ-YAX800G is attached).
Displayed when proxy recording stops because of failure on either the video
encoder card or the stream.(when AJ-YAX800G is attached).
Displayed when a failure occurs on the SD memory card during proxy recording,
and only recording on the SD memory card stops.(when AJ-YAX800G is attached).
Voice memo being recorded. When the free space for voice memos is less than
one minute, the indication blinks.
Selected channel together with its audio level.
AUDIO IN switch is positioned at FRONT.
AUDIO IN switch is positioned at WIRELESS.
AUDIO IN switch is positioned at REAR.
TCG (time code generator value)
TCR (time code reader value)
UBG VUBG
UBR VUBR.
Displays CTL count.
DV format specified and playback being performed in the DV format.
Correction phase of the iris override (when active)
+ + : On the open side by 1
– – : On the closed side by 1
No indication : Standard status
Lens cable is not connected.
Lens iris is at maximum.
Lens iris value
Lens iris closed.
<Note>
These indications are provided when the lens is capable of indicating the iris value.
When the iris is being overridden, they blink.
Zoom degree is indicated. This indication is not provided for a lens that does not
return the zoom position, even if the indication is set to ON.
Displayed before and after operation during INTERVAL REC mode.
Displayed during INTERVAL REC operation.
Displays the pause time before the next recording during INTERVAL REC.
Indicated while pre-recorded video and audio are being recorded on the P2 card.
The ID is set to be superimposed on the video from the camera.
Status
MODE CHECK
+: On the open side by 0.5
–: On the closed side by 0.5
is