Panasonic AJ-SPX800P Operating Instructions Manual page 48

Information Item
Camera Shooting
Mode
Extender
MODE CHECK
Indication Area
(STATUS:
Master gain,
USER SW GAIN)
(Cause of !LED
illumination: displayed
full-screen)
Indications selected
through the menu option
!LED are marked with [ ! ].
Indications which may
activate the !LED are
marked with [ ].
(FUNCTION:
VIDEO OUT)
(FUNCTION:
MONI OUT)
(FUNCTION:
P2CARD STATUS)
(AUDIO: Enabling or
disabling the FRONT
AUDIO LEVEL control)
(AUDIO: Power status
for the microphone)
(AUDIO: Input signal
and level for each
channel)
Downloaded From VideoCamera-Manual.com Manuals
48
Indication
60i, 30P, 24P, 24PA
EX2
LOW/MID/HIGH
–3 to 30
S.GAIN 30/36/42/48
DS.GAIN 6 /12 /20
GAIN (0 dB)
GAIN (–3 dB)
DS.GAIN
SHUTTER
WHITE PRE.
EXTENDER
BLACK STR.
MATRIX
COLOR COR.
FILTER
SUPER V
50M/25M/DV
ATW
D.ZOOM
SW: MEM/CAM/OFF
SELECT: VBS/VF/Y/SDI
CHAR: ON/OFF
SW: MEM/CAM/OFF
CHAR: ON/OFF
TOTAL
SLOT1/SLOT2/SLOT3/SLOT4/
SLOT5
OP-SLOT
CH1: ON/OFF
CH2: ON/OFF
FRONT: ON/OFF
REAR: ON/OFF
FRNT/W.L./REAR
CH1/2/3/4
Camera shooting mode (progressive or interlaced)
Lens extender used.
Value set for the master gain
Example: LOW: 0
Gain value to which S.GAIN and DS.GAIN are assigned
Gain status
Gain status
DS. GAIN value
Shutter status
White balance status
Extender status (EX2 or OFF)
Black stretch status (ON or OFF)
MATRIX status (A, B, or OFF)
Color correction status (ON or OFF)
Filter status
SUPER V status (ON or OFF)
Recording mode (50M, 25M, or DV)
ATW status (ON or OFF)
Digital zoom status (ON or OFF)
Position of OUTPUT SEL switch.
Setting for menu option VIDEO OUT SEL. This option can be found in the
<OUTPUT SEL> screen, which is accessible from the SYSTEM SETTING page.
Position of VIDEO OUT CHARACTER switch
Position of OUTPUT SEL switch.
The setting for menu option MONITOR OUT CHAR. This option can be found in
the <OUTPUT SEL> screen, which is accessible from the SYSTEM SETTING
page.
Total remaining free space/capacities of the P2 cards loaded in P2 Card Slots 1 - 5
Remaining free space/capacity of each card. The numbers denote the P2 card slot
numbers.
The card status is indicated as:
ACTIVE/ACTIVE!/ACCESSING/INFO READING/FULL/PROTECTED/
NOT SUPPORTED/FORMAT ERROR/NO CARD/PROXY
For details of statuses, see [P2 CARD ACCESS LED and status of P2 cards] (page
23).
Indicates optional slot status.
The card status is indicated as:
PROXY/NO CARD/NOT SUPPORTED
If the FRONT AUDIO LEVEL control is in effect for Channel 1, then ON is
indicated. If not, OFF is indicated.
If the FRONT AUDIO LEVEL control is in effect for Channel 2, then ON is
indicated. If not, OFF is indicated.
Power status of the front microphone
Power status of the rear microphone
For more information, see [8-6-5 MIC/AUDIO2].
Input signal and level for each channel
Status